rclone rcat ​

Copies standard input to file on remote.

Synopsis ​

Reads from standard input (stdin) and copies it to a single remote file.

echo "hello world" | rclone rcat remote:path/to/file
ffmpeg - | rclone rcat remote:path/to/file

If the remote file already exists, it will be overwritten.

rcat will try to upload small files in a single request, which is usually more efficient than the streaming/chunked upload endpoints, which use multiple requests. Exact behaviour depends on the remote. What is considered a small file may be set through --streaming-upload-cutoff. Uploading only starts after the cutoff is reached or if the file ends before that. The data must fit into RAM. The cutoff needs to be small enough to adhere the limits of your remote, please see there. Generally speaking, setting this cutoff too high will decrease your performance.

Use the --size flag to preallocate the file in advance at the remote end and actually stream it, even if remote backend doesn't support streaming.

--size should be the exact size of the input stream in bytes. If the size of the stream is different in length to the --size passed in then the transfer will likely fail.

Note that the upload cannot be retried because the data is not stored. If the backend supports multipart uploading then individual chunks can be retried. If you need to transfer a lot of data, you may be better off caching it locally and then rclone move it to the destination which can use retries.

rclone rcat remote:path [flags]

Options ​

  -h, --help       help for rcat
      --size int   File size hint to preallocate (default -1)

Options shared with other commands are described next. See the global flags page for global options not listed here.

Important Options ​

Important flags useful for most commands

  -n, --dry-run         Do a trial run with no permanent changes
  -i, --interactive     Enable interactive mode
  -v, --verbose count   Print lots more stuff (repeat for more)

See Also ​

• rclone - Show help for rclone commands, flags and backends.