Appearance
rclone delete
Remove the files in path.
Synopsis
Remove the files in path. Unlike purge it obeys include/exclude filters so can be used to selectively delete files.
rclone delete
only deletes files but leaves the directory structure alone. If you want to delete a directory and all of its contents use the purge command.
If you supply the --rmdirs
flag, it will remove all empty directories along with it. You can also use the separate command rmdir or rmdirs to delete empty directories only.
For example, to delete all files bigger than 100 MiB, you may first want to check what would be deleted (use either):
rclone --min-size 100M lsl remote:path
rclone --dry-run --min-size 100M delete remote:path
Then proceed with the actual delete:
rclone --min-size 100M delete remote:path
That reads "delete everything with a minimum size of 100 MiB", hence delete all files bigger than 100 MiB.
Important: Since this can cause data loss, test first with the --dry-run
or the --interactive
/-i
flag.
rclone delete remote:path [flags]
Options
-h, --help help for delete
--rmdirs rmdirs removes empty directories but leaves root intact
Options shared with other commands are described next. See the global flags page for global options not listed here.
Important Options
Important flags useful for most commands
-n, --dry-run Do a trial run with no permanent changes
-i, --interactive Enable interactive mode
-v, --verbose count Print lots more stuff (repeat for more)
Filter Options
Flags for filtering directory listings
--delete-excluded Delete files on dest excluded from sync
--exclude stringArray Exclude files matching pattern
--exclude-from stringArray Read file exclude patterns from file (use - to read from stdin)
--exclude-if-present stringArray Exclude directories if filename is present
--files-from stringArray Read list of source-file names from file (use - to read from stdin)
--files-from-raw stringArray Read list of source-file names from file without any processing of lines (use - to read from stdin)
-f, --filter stringArray Add a file filtering rule
--filter-from stringArray Read file filtering patterns from a file (use - to read from stdin)
--ignore-case Ignore case in filters (case insensitive)
--include stringArray Include files matching pattern
--include-from stringArray Read file include patterns from file (use - to read from stdin)
--max-age Duration Only transfer files younger than this in s or suffix ms|s|m|h|d|w|M|y (default off)
--max-depth int If set limits the recursion depth to this (default -1)
--max-size SizeSuffix Only transfer files smaller than this in KiB or suffix B|K|M|G|T|P (default off)
--metadata-exclude stringArray Exclude metadatas matching pattern
--metadata-exclude-from stringArray Read metadata exclude patterns from file (use - to read from stdin)
--metadata-filter stringArray Add a metadata filtering rule
--metadata-filter-from stringArray Read metadata filtering patterns from a file (use - to read from stdin)
--metadata-include stringArray Include metadatas matching pattern
--metadata-include-from stringArray Read metadata include patterns from file (use - to read from stdin)
--min-age Duration Only transfer files older than this in s or suffix ms|s|m|h|d|w|M|y (default off)
--min-size SizeSuffix Only transfer files bigger than this in KiB or suffix B|K|M|G|T|P (default off)
Listing Options
Flags for listing directories
--default-time Time Time to show if modtime is unknown for files and directories (default 2000-01-01T00:00:00Z)
--fast-list Use recursive list if available; uses more memory but fewer transactions
See Also
- rclone - Show help for rclone commands, flags and backends.